|
| FAQ Inkjet Media & Textiles
1. Why do I need ICC profiles?
2. When do you laminate an inkjet print?
3. How do you finish Inkjet Fabrics?
1. Why do I need ICC Profiles?
The use of ICC profiles is based on the personal preference and experience of the end user. Generally they are a useful tool and assist in providing the correct ink balance that enables a good image quality and lamination adhesion. SEAL provides a range of comprehensive profiles that are aimed at fulfilling the end user needs.
Top
2. When do you laminate an inkjet print?
When the desired longevity of the print cannot be obtained without extra protection and or to enhance the image.
The time to laminate after printing, depends on the type of media and the amount of ink that is being applied:
A general “safe” recommendation is 12 hours or more (overnight), although
due to time constraints, this may not always be practical.
If a gloss or filmic media with high ink saturation is used then a 12 hour period
(depending on geographic location) is recommended.
If a matte paper with low ink saturation is used then 4 hours should be adequate.
Testing prior to creating the application resolves the majority of issues that may
occur in any given geographical location and avoids delays or the expense of
repeating the work at a later date.
Top
3. How do you finish Inkjet Fabrics?
Generally, fabrics are not finished with lamination however in a flat application, a vinyl lamination can be used.
Other forms of finishing without lamination depend upon the type of fabric. Synthetic fabrics can be cut with a hot knife and welded or stitched when turned. Natural fabrics must only be turned then stitched. When stitching it is important to use similar thread to the material being stitched (i.e. natural heavy thread made from the same material as the fabric). Lastly when turning, back up the fabric with a suitable and equivalent webbing to reinforce the fabric for eyelets etc.
Top
back |